Tips - How to buckle a cuban link bracelet & how to disassemble a cuban link bracelet
1. How to buckle a cuban link bracelet
To buckle the cuban link bracelet, first find the U-shaped metal ring at one end of the bracelet, open the metal cover at the other end of the bracelet, put the metal ring on the metal strip, cover the metal cover and press it. It is more appropriate to wear the cuban link bracelet with the left hand. Most people use the left hand less frequently. Wearing the cuban link bracelet in the left hand can reduce the chance of collision.
Method of fastening cuban link bracelet
When you want to buckle the cuban link bracelet, you need to find the U-shaped metal ring at one end of the bracelet, and then open the metal cover at the other end of the bracelet. At this time, you can see that there is a protruding metal strip in the middle of the other end of the bracelet. At this time, you need to cover the metal ring on the metal strip, and finally cover and press the metal cover.
When wearing a cuban link bracelet at ordinary times, it is recommended to wear the bracelet on your left hand. Most people use their left hand less frequently. Wearing a cuban link bracelet on their left hand can reduce the chance of collision, which is very helpful for the maintenance of bracelets.
In addition, during wearing the cuban link bracelet, it is recommended to clean the bracelet regularly. After wearing the bracelet for a long time, a large amount of dust and dirt will gradually accumulate on the surface. Clean it regularly and pay attention to maintaining the beauty of the bracelet.
2. How do I break a cuban link bracelet
Turn over the tail buckle and its opening direction close to the fitting. The fitting opening can take out the tail relatively. Take out a fitting in the same way, reinstall the tail, and finally turn over the opening direction
Flip tail buckle
Turning direction of tail buckle
Flip fitting opening direction
Tilt the fitting close to the tail buckle, find the lowest point, and turn the opening direction
Take out the accessories
The openings on both sides of the accessories are opposite to each other and can be taken out
Take out the next accessory
In the same way, turn the opening direction and take out a fitting
Install the tail
The opening intersects the tail taken out before installation, and the tail fittings and side buckles shall be turned in the same direction to keep the overall direction consistent